If your pup likes to tip their outdoor water bowl then this pet bowl stand is for you!
Materials:
- Pet Bowl w/ a rim
- [2] Outdoor pots
- Exterior construction adhesive
Step 1:
Pick out two flower pots with a bit of weight to them. If you use lightweight plastic pots then this stand will most likely be tipped by your pet.
Take both of your outdoor flower pots and flip one of them over. You will be stacking them and attaching the bottoms to each other.
Step 2:
Apply your exterior construction adhesive to the bottom of the lower bowl. Be sure to avoid the drainage hole. Add the second flower pot to the adhesive and allow to fully cure. Depending on the adhesive this could be up to 48 hours.
Step 3:
This step depends on the size of your pet bowl. If the rim sits on top of the pot perfectly then you’re good to go. If not, you can add rocks to the pot for your bowl to sit at the right height. (I had another small pot that I used to put the bowl on.)
